In-Mould Label vs Sticker Label for Plastic Containers

18 November 2026 · TopGuard, DVM Protech

The in-mould label vs sticker label question comes up whenever a plastic container maker looks at their decoration cost. Both put a printed graphic on a container, but they do it at different points in your process, and the right answer depends on your volume, your SKUs and whether you can change the moulding line.

How each one works

An in-mould label is a pre-printed polypropylene film placed in the mould before injection. Heat and pressure fuse it with the container wall, so it becomes part of the container. A sticker label is a self-adhesive label applied after moulding, on a separate labelling machine.

Where in-mould labels win

  • It cannot peel. There is no separate layer, so no lifted corner, bubble or curl after months in a warehouse.
  • No secondary operation. Decoration happens inside the moulding cycle. You remove the labelling machine, the labour on that line, the adhesive and the rejects that come with post-mould labelling.
  • Recycling. A polypropylene label on a polypropylene container goes into one recycling stream with no label-separation step.
  • Print quality. Rotogravure holds sharp images, deep solids and fine text.
  • Faster SKU changes. Change the label stack and you change the SKU.

Where sticker labels still make sense

A sticker label does not need a decorated mould or a change to the moulding process. It suits very short runs, many different SKUs on one container, or a line where you cannot touch the mould. The cost is a labelling step, an adhesive layer, and a silicone release liner left over after every label is applied.

The third option: heat transfer

If you cannot change the moulding process but want the sticker gone, heat transfer labels decorate a finished container on a separate machine. There is no label edge and no liner, only a spent carrier web. It suits mixed and shorter runs better than IML, which fits dedicated high-volume SKUs best.

How to decide

Look at three things: volume per SKU, whether you control the mould, and how long the container sits on a shelf. High volume on a dedicated mould points to IML. Short runs or an untouchable line point to stickers or heat transfer. If your container is blow moulded rather than injection moulded, you need a different film, explained in blow mould label vs in-mould label.

Not sure which fits? Send us your container and volumes and we will tell you honestly, including when the answer is not IML.

WhatsApp us
Scroll to Top